Wiring; Commissioning - SOMFY Tilt & Lift 25 RTS Central Instructions Manual

2.2. WIRINg

Cables which pass through a metal wall must be protected and isolated using a sheath
or sleeve.
Attach cables to prevent any contact with moving parts.
The cable for the Tilt & Lift 25 RTS Central cannot be removed. If it is damaged,
return the drive to the After-Sales department.

Leave the motor power supply cable accessible: it must be possible to replace it
easily.

Do not unplug the battery when the motor is working.
Plug the battery or the power supply with the
motor supply cable :
Do not unplug the battery or the power

supply when the motor is working.

2.3. CoMMISSIoNINg

2.3.1. Programming the RTS control point
Press the Up and down buttons
simultaneously on the RTS control point:
the motorised product moves up and down
and the control point is preprogrammed in the
motor
2.3.2. Checking the direction of rotation
Press the Up button on the RTS control point:
a) If the motorised product rises (a), the
direction of rotation is correct: Move onto the
section 5.3 entitled "Setting the end limits".
b) If the motorised product lowers (b), the
direction of rotation is incorrect: Move onto the
next step.
b1) Press the my button on the RTS control
point until the motorised product moves
up and down: The direction of rotation has
been modified.
b2) Press the Up button on the RTS control
point to check the direction of rotation.
6
b1
Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
a
=
b
=
b2