Tips And Recommendations For Installation - SOMFY Tilt & Lift 25 RTS Central Instructions Manual

2.4. TIPS aNd RECoMMENdaTIoNS FoR INSTaLLaTIoN

2.4.1. questions about the Tilt & Lift 25 RTS Central?
Observations
There may be some radio
interferences.
The motorised
product does not
One or more batteries have been
operate.
mounted backwards.
One or more batteries leak in the
battery tube.
Batteries (inside battery tube) are
weak.
The control point battery is weak.
The control point is not
compatible.
The control point used has not
been programmed into the motor.
To press on the motor PRog button, it's best to use the motor antenna. The

use of other tools could damage the PRog button.
2.4.2. Re-setting the end limits
Readjusting the upper end limit
1) Press the Up button to bring the
motorised product to the end limit to be
readjusted.
2) Press the Up and down buttons at the
same time until the motorised product moves
up and down.
3) Press the Up or down button to move
the motorised product to the new desired
position.
4) To confirm the new end limit, press the
my button until the motorised product moves up and down.
8
Possible causes
3
Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
Solutions
Unplug the motor supply cable
and reconnect the battery tube to
the motor.
Verify that batteries are all
mounted in the correct manner.
Replace the batteries
Check whether the batteries are
weak and replace if necessary.
Check whether the battery is
weak and replace it if necessary.
Check for compatibility and
replace the control point if
necessary.
Use a programmed control point
or program this control point.
1 2
4