SOMFY Tilt & Lift 25 RTS Central Instructions Manual page 7

2.3.3. Setting the end limits
The end limits can be set in any order.
Do not set the upper end limit in a position in which the fabric or slats are fully

pressed against the headrail, as this could damage the motorised product and/or
the motor in the long term.
1) Raise the motorised product to the desired
position by pressing the Up button.
2) Press the my and down buttons at the
same time until the motorised product moves.
The upper end limit is memorised.
3) Press the my button when the motorised
product reaches the desired lowered position.
If necessary, adjust the position of the
motorised product using the Up and down
buttons.
4) Press the my and Up buttons at the same
time until the motorised product moves.
The lower end limit is memorised. The
motorised product rises and stops in the
raised position.
5) To confirm the end limits, press the my
button until the motorised product moves up
and down.
The end limits are programmed.
2.3.4. Recording the RTS control point
The motorisation is in programming mode:
Quickly press the PROG button on the RTS
control point to be programmed:
The motorised product moves up and down:
this RTS control point is programmed in the
motorisation.
If the motorisation is no longer in programming mode, repeat Step 2.3.1 then
perform Step 2.3.4.
Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
1
3
5
PROG.
2
4
7