SOMFY Altus RTS 120 V Quick Programming Manual

QUICK PROGRAMMING GUIDE FOR ALL RTS MOTORS
Altus RTS 120 V / Sonesse 30
Please refer to individual instructions for more details
Programming Mode
Before you begin
Motors are shipped without limit settings and transmitter ID's. Steps 1 to 7 must
be completed to ensure proper shade programming and functionality. Power should
ONLY be connected to current shade being programmed. All other shades should be
disconnected from their respective power while programming
STEP 1: Connect power
With the motor installed in shade, connect power to
the motor (120V, or 12 V or 24V transformer or 12 V
battery wand)
STEP 2: I nitiate programming
Press both and
jogs. A jog is a brief up and down motion.
Mode, the shade will move only when the
STEP 3: Check directions
Press or . When pressing
go down or out. To change direction press and hold
(Stop) until the shade jogs.
and down motion.
Adjusting the limits in User Mode
To change the lower limit To change the lower limit To change the lower limit
Send the shade to it's current Send the shade to it's current Send the shade to it's current
lower limit. lower limit. lower limit.
To change the upper limit
Send the shade to it's current
upper limit.
Setting an Intermediate Position (Preferred Position)
Setting
Press the or to operate shade. At the desired intermediate
(preferred) position press (Stop) to stop the shade.
Once the desired Intermediate position is reached, Press and
hold (stop) until the shade jogs. The Intermediate position
is now added to memory
Adding or deleting a Transmitter or a Channel
Programmed Transmitter
STEP 1: Using already programmed transmitters select the transmitter (single channel) or the channel, (1-5)
of a multi-channel transmitter.
STEP 2: Press and hold the programming button of that transmitter until the shade jogs.
Transmitter to add or delete
STEP 3: Select the transmitter (single channel) or the channel, (1-5) of a multi-channel transmitter, to be
added or deleted.
STEP 4: Press and hold the programming button of that transmitter until the shade jogs.
TM TM
24V / Wirefree Roll Up LT-30RT Round Head & CORD Lift CT-32 Motors.
at the same time until the shade
In Programming
or is held
product should
A jog is a brief up
Press both
time until the shade jogs. Adjust to
a new lower limit position.
Press both
time until the shade jogs. Adjust to
a new upper limit position.
STEP 4: Set the limits
Bring the shade to desired upper limit stop point. Press both
(Stop) and until the motor moves, then release. (If the shade
stops when the buttons are released take it back to the upper limit
and repeat) Stop the motor when reaching the desired lower limit.
You can adjust by pressing
STEP 5: Set the limits
Press both (Stop) and
shade moves, then release. The shade will stop at the original
upper limit.
STEP 6: Confirm limit settings
Press and hold (stop) until the shade jogs to confirm
the limit settings. A jog is a brief up and down motion.
STEP 7: Set user mode
Press and hold the programming button on the
back of the transmitter until the shade jogs. The
shade is now in User Mode. In User Mode, the
shade will operate with a brief press on
Double check limit settings as a precaution.
Press
and at the same
and at the same
Press
Using
Send the shade to the intermediate position by pressing
from ANY shade position.
Note: Shade should be stationary prior to activating intermediate
position function.
Note
If shade is actively moving (in-motion)
To Delete: Activate shade to intermediate position, then press and
hold (stop) for 5 seconds. Shade will jog to confirm deletion.
or
at the same time until the
or
until the shade jogs
until the shade jogs
(stop)
Should be pressed twice.