Waeco MAGIC Control MTPM-100 Installation And Operation Manual page 64

MTPM-100.book Seite 64 Freitag, 15. Juli 2005 4:37 16
Using MAGIC CONTROL
9.2 Programming the tyre sensors
Note
During programming, MAGIC CONTROL calls each tyre sensor
in a set order. If you only want to program one tyre sensor, for
example because you have replaced it, you do not reprogram
the sensors which are already installed.
This is how to program the sensors:
➤ Press and hold down the display button.
➤ Switch the ignition on.
➤ Let go of the display button after the controller has emitted a high-pitched
beep.
Front left tyre sensor
✓ The LED flashes green every 3 seconds to indicate the front left tyre.
➤ If you want to program the sensor in the front left tyre, let down the tyre
pressure by 0.2 bar.
✓ The controller confirms the sensor with a high-pitched beep.
➤ If you do not want to program this sensor, press the display button.
✓ The controller remembers the previously installed sensor.
✓ The controller confirms the setting with a high-pitched beep.
Front right tyre sensor
✓ The LED flashes green twice every 3 seconds to indicate the front right
tyre.
➤ If you want to program the sensor in the front right tyre, let down the tyre
pressure by 0.2 bar.
✓ The controller confirms the sensor with a high-pitched beep.
64
MAGIC CONTROL