Safety And Installation Instructions - Waeco MAGIC Control MTPM-100 Installation And Operation Manual

MTPM-100.book Seite 49 Freitag, 15. Juli 2005 4:37 16
MAGIC CONTROL
2

Safety and installation instructions

Please observe the prescribed safety instructions and stipulations
from the vehicle manufacturer and service workshops.
Caution
WAECO International will not be held liable for claims for damage
resulting from the following:
– Installation errors
– Damage to the system resulting from mechanical influences
and overvoltage
– Alterations to the device made without the explicit permission
of WAECO International
– Usage for purposes other than those described in the
installation instructions
Warning
To prevent short circuits, always disconnect the negative terminal
of the electrical system before working on the vehicle.
If the vehicle has an additional battery, its negative terminal should
also be disconnected.
Warning
Insufficient supply line connections could result in short circuits
which:
– Cause cable fires
– Trigger the airbag
– Damage electronic control devices
– Cause electric functions to fail (indicators, brake light, horn,
ignition, lights)
Please observe the following instructions:
When working on the following supply lines, only use insulated cable lugs,
plugs and tab sleeves.
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return line from the battery, earth).
Do not use plastic terminal strips.
Use a crimping tool (1 10, page 3) to connect the cables.
For connections which are intended to be permanent, you can solder the
cable ends together and then insulate them.
Safety and installation instructions
49