Waeco MAGIC Control MTPM-100 Installation And Operation Manual page 65

MTPM-100.book Seite 65 Freitag, 15. Juli 2005 4:37 16
MAGIC CONTROL
➤ If you do not want to program this sensor, press the display button.
✓ The controller remembers the previously installed sensor.
✓ The controller confirms the setting with a high-pitched beep.
Rear right tyre sensor
✓ The LED flashes green three times every 3 seconds to indicate the rear
right tyre.
➤ If you want to program the sensor in the rear right tyre, let down the tyre
pressure by 0.2 bar.
✓ The controller confirms the sensor with a high-pitched beep.
➤ If you do not want to program this sensor, press the display button.
✓ The controller remembers the previously installed sensor.
✓ The controller confirms the setting with a high-pitched beep.
➤ If you do not want to program any more sensors and only use the front
left and right tyre sensors (trailer mode), press the display button for
3 seconds.
This function is only required when using MAGIC CONTROL with two-
wheel caravans or trailers.
✓ The controller confirms the deletion with a high-pitched beep.
✓ The controller quits tyre sensor programming mode.
✓ The system is in operating mode.
Rear left tyre sensor
If you have not quit tyre sensor programming mode:
✓ The LED flashes green four times every 3 seconds to indicate the rear
left tyre.
➤ If you want to program the sensor in the rear left tyre, let down the tyre
pressure by 0.2 bar.
Using MAGIC CONTROL
65