Otto Bock 5R2 Instructions For Use Manual page 16

► Follow the instructions regarding the length of the screws and about
how to secure the screws.
Selection table for countersunk head screws
Chosen socket adapter
4R22, 4R23, 4R54, 4R55, 4R73=A,
4R73=D, 4R74, 4R95
4R37, 4R51, 4R77
Required tools and materials:
>
Sanding tools, 636K13 Loctite®, 710D4 torque wrench
1) CAUTION! Do not sand the laminate around the edge of the
product!
Sand the laminate on the distal end of the prosthetic socket down to the
surface of the lamination dummy (see fig. 6).
2) Remove the lamination dummy.
3) If the 6A30=20 shuttle lock was used: Remove the 6 oval head self-
tapping screws.
4) Select the correct countersunk head screws to connect the socket
adapter to the lamination disc (see selection table).
5) Secure the screws with Loctite®.
6) CAUTION! Observe the minimum screw insertion depth of 8 mm!
Install the socket adapter with 4 countersunk head screws. Observe the
instructions and installation torque values in the socket adapter instruc­
tions for use.
6 Maintenance
► The prosthetic components should be inspected after the first 30 days of
use.
► Inspect the entire prosthesis for wear during normal consultations.
► Conduct annual safety inspections.
7 Disposal
This product may not be disposed of with regular domestic waste in all juris­
dictions. Disposal that is not in accordance with the regulations of the coun­
try where the product is used may have a detrimental impact on health and
the environment. Please observe the information provided by the responsible
authorities in the country of use regarding return, collection and disposal
procedures.
16
Screws to be used
501S41=M6x12
501S41=M6x16