Table of Contents
Advertisement
(2) Insert the end of the drive shaft on middle con-
veyor into a hole on the rear frame.
(3) Insert the end of shaft into a cutout in the front
frame.
(4) Tighten the locking screw removed in step (1) to
attach the parts.
Attach the accessory gear to the QC-S300F.
(1) Attach the accessory gear to the rear of the
machine.
(2) Attach the gear using a clevis pin.
(3) Rotate the pulley by hand and check that the gear
turns smoothly.
(4) Attach the gear cover using three screws.
Important
• Be careful that the nearby cables are not caught.
How to Install Multiple QC-S300F Collators
End of shaft
Locking Screw
End of shaft
QC-S300F
Drive Shaft
2109650202H1
2109650202I1
2109650202J1
Clevis Pin
Gear
Drive Shaft
2109650202K1
Gear Cover
Cables
2109650202L1
58
Advertisement
Table of Contents
