Table of Contents
Advertisement
Offset Receiving
Stacking Area:
Width x Length: 180 x 175 mm
(7.1" x 6.9") or more
Width x Length: 300 x 432 mm
(11.8" x 17.0") or less
Backstop
Front
50 mm (2")
Guides
Initial Screen
Bin Support
2109630401C1
Straight Receiving
Stacking Area:
Width x Length: 138 x 175 mm
(5.5" x 6.9") or more
Width x Length: 305 x 432 mm
(12.0" x 17.0") or less
Backstop
Front
Guides
2109630301E1
Receiving Tray
Straight
Offset
Select
2109630301F1
When feeding non-standard size sheets on either the
short or long edge:
Load the sheets into the bins.
• Load the sheets into the bins in the position shown in
the illustration to the left.
• If the long edge of the sheet is 420 mm (16.5") or more,
pull out the bin support.
Set the receiving tray.
• Offset Receiving
(1) Position the backstop. Set the front guides 50 mm (2")
away from the edge of the stack.
(2) If the backstop and front guides do not support the
stack, use the support stopper.
• Straight Receiving
(1) Position the backstop and the front guides against the
edges of the sheet as it sits on the receiving tray.
(2) If the backstop and front guides do not support the
stack, use the support stopper.
Set the receiving mode.
• Select the receiving mode (straight or offset) on the Ini-
tial screen.
Start the collating operation.
Important
• If the sheets are not stacked correctly because of
static electricity, reset the backstop 10 to 20 mm (0.4
to 0.8") away from the edge of the stack.
22
Advertisement
Table of Contents
