Table of Contents
Advertisement
How to Set the Receiving Tray
The positions of the guides and backstop on the receiving tray depend on the receiving mode and the sheet size.
There are two ways to stack the collated sheets on the receiving tray. Select "offset receiving" or "straight receiving."
Receiving Tray
Front Guides
Support Guide
Additional Information
Offset Receiving
7
Rear Guides
2109620201A1
Backstop
2109620201B1
Backstop
50 mm (1.97")
2109620201C1
. Initial Screen
Select
2109620201D1
Offset Receiving
Move the rear guides to the far side of the
receiving tray.
For standard size sheets (except for A5 / 5.5" x
8.5"):
Set the front guides and backstop.
• Position the front guides and the backstop according
to the sheet size indications on the receiving tray.
For A5 / 5.5" x 8.5" sheets:
Set the backstop and the support guide.
• Place one sheet on the receiving tray, then position
the backstop so that it just touches the sheet. Place
the support guide 50 mm (1.97") away from the near
edge of the sheet.
• In the offset receiving mode, each collated set is offset
as it is stacked in the receiving tray.
• When the main power is turned on, offset receiving is
selected by default.
• See "How to Load and Stack Non-Standard Size
Sheets" on page 21 when collating A4 / 8.5" X 11"
sheets which feed along the long edge.
• If the sheets are not stacked correctly because of static
electricity, move the backstop 10 to 20 mm (0.4" to 0.8")
farther away from the edge of the stack.
Advertisement
Table of Contents
