Table of Contents
Advertisement
How to Install a Single QC-S300 Collator
Installing a Single QC-S300 Collator
CAUTION
• Do not install the QC-S300 on an unstable
floor. The machine may fall over. The
machine frame may be twisted, and this
could affect the machine performance.
• The QC-S300 weighs about 73Kg (160.6
lb). This machine must be installed by at
least two people.
1.
Unpack the collator.
• This machine must be moved by at least two people.
• Check the accessories. (Refer to page 48.)
2.
Install the QC-S300 by following the steps
below.
(1) Replace two of the plastic feet on the bottom of
the machine with the plastic feet used with the
MT-100 table. Attach the plastic feet used with the
optional MT-100 table using the mounting screws.
(2) Place the QC-S300 on the MT-100 table so that the
feet on the QC-S300 fit into the holes on the MT-
100.
Important
• Place the MT-100 in the correct direction referring
to the illustration to the right.
(3) Attach the QC-S300 using two screws.
(4) Move the machine to the required location.
Important
• Be sure to push the bottom of the transport door side
of the QC-S300 when moving the machine. Do not
push the bin side. This could cause the QC-S300 to
fall over.
(5) Lock the casters on the MT-100 table.
53
Stand-Alone Unit: QC-S300
Optional Table: MT-100*
* If you are installing QC-S300 on any table except
the MT-100, choose a stable table which can sup-
port at least 80 kg (176 lb).
Width: Wide
QC-S300
Plastic Feet
2109650101A1
Width: Narrow
MT-100
1110950101B1
2109650101C1
Advertisement
Table of Contents
