Table of Contents
Advertisement
Roller Shaft
2
Front Side of Machine
Rear Side
1
2
Marks on
the side
of the roller
U-shaped Cutout
Projection
Replacing a Feed Roller
Turn off the power switch.
• Turn off the main power switch for the QC-S300 and
unplug the power cord.
2109640201A1
1
Remove the roller shaft.
• Pull the shaft and feed roller toward the near side of
the machine.
• Pull out the right end of the shaft.
2109640201B1
Replace the feed roller.
• When installing the new feed roller on the roller
shaft, face the marks on the side of the roller toward
the rear of the machine. Lock the feed roller against
the flange of the wheel.
Feed Roller
Marks
Important
• If the feed roller is installed in the wrong direction,
misfeeding may occur.
2109640201E1
Install the roller shaft.
• When re-assembling, insert the projection on the
roller shaft to the U-shaped cutout on the fixed end
of the shaft.
2109640201D1
WARNING
Turn off the main power switch and unplug
the power cord whenever the feed roller is
cleaned or replaced.
36
Advertisement
Table of Contents
