Table of Contents
Advertisement
Trouble: Poor Arrangement of Sheets
Poor Arrangement of Sheets
Check
The sheets in the bins
are not stacked cor-
rectly.
Check whether the
sheets are bent or
curled.
Check whether the sheet
is stuck on the support
roller.
Check whether the
sheets in the bin are
higher 28 mm (1.1").
Check whether the front
guide is set against the
edge of the stack too
tightly, or too loosely.
Check whether the
sheets are held together
by static electricity.
Check whether the col-
lated sets are leaning to
either side on the receiv-
ing tray.
Causes and Remedies
Fan and stack the sheets correctly before load-
ing them into the bins.
2109640103D1
Check the sheets in the bins and remove any
sheets which are bent or curled.
2109640106A1
Check the bins and remove any sheet which is
Support
stuck on the support roller.
Roller
2109640103C1
Do not load sheets in the bin higher than 28
28 mm (1.1")
mm (1.1").
2109640102E1
If the front guide is set too tight, set the
guide so that it just touches the edge of the
stack. If the front guide is set too loose, posi-
tion the front guide up against the stack
without any gap.
2109640102A1
Reset the backstop 10 to 20 mm (0.4" to
0.8") away from the edge of the stack.
10 mm (0.4")
to 20 mm (0.8")
2109640106B1
Move the backstop to the side where the
Receiving
sheets are leaning.
Tray
2109640106C1
Page
Page 5
-
-
-
Page 5
Page 7,8
-
32
Advertisement
Table of Contents
