General; About This Guide; Requirements; The Thinkio-P - Kontron ThinkIO-P Quick Start Manual

ThinkIO - P
™
1.

General

1.1

About This Guide

This Quick Start Guide is designed to provide information necessary to quickly install and begin
operations with the ThinkIO-P. It begins with unpacking and ends with the ThinkIO-P being
ready for operation in an application development environment. It includes not only the
ThinkIO-P, but also, where applicable, makes references to optionally available WAGO-I/O-
SYSTEM-750/753 I/O modules. Operating system or application software descriptions are not
part of this guide. Refer to the appropriate programming guide or application documentation for
further information concerning software.
The use of this guide requires that all applicable safety requirements are complied with in order
to prevent bodily harm or damage to the equipment involved.
This guide is designed to be read sequentially and is, as such, a procedure in itself. Do not skip
over subjects unless they have been previously read and understood.
The information and all of the instructions and procedures provided in this guide must be taken
into account or complied with to avoid improper operation or damage to the equipment.
1.2

Requirements

This guide assumes that the ThinkIO-P application requirements and system configuration
have been defined and that this information and all other required elements of the application
are available to the integrator at the time the procedures of this guide are applied.
1.3

The ThinkIO-P

The ThinkIO-P is an industrial PC packaged in an assembly, 224 x 70 x 100 mm, for mounting
on a DIN rail. It can be complemented with WAGO-I/O-SYSTEM-750/753 input and output
modules using the optional WAGO interface module (K-Bus) for controlling of the I/O modules.
The following figure demonstrates this configuration.
Figure 1-1: ThinkIO-P with the WAGO Interface Module (K-Bus) Assembled on the Right
X11 USB1
ACT/LNK Speed ACT/LNK Speed
X10 USB0
X8 ETH0 X9 ETH1
X6 RS232
X5 I/O
RST
X4 Power
ID 29867.01, Rev. 01
QUICK START GUIDE
SP:
Diag:
Run
Stop
X7 DVI
© 2005 Kontron Modular Computers GmbH
General
A
C
B
D
+ +
- -
Page 1