The Wago Interface And I/O Modules; Unpacking The Thinkio-P; Mounting; Software And Documentation - Kontron ThinkIO-P Quick Start Manual

General
1.4

The WAGO Interface and I/O Modules

The WAGO-I/O-SYSTEM-750/753 families of industrial input and output modules is option-
ally available for usage with the ThinkIO-P. This option requires the WAGO interface module
(K-Bus) for interfacing between the ThinkIO-P and the WAGO I/O modules. Through the
WAGO interface module (K-Bus) access is gained to a wide variety of industrial digital and
analog input/output devices as well as special encoders and counters.
1.5

Unpacking the ThinkIO-P

The ThinkIO-P is shipped in appropriate packaging material. This packaging material should
be retained for future use if it is necessary to return the product for servicing.
To unpack the ThinkIO-P proceed as follows:
1. Observing ESD requirements, carefully open the packaging and remove its contents.
2. Verify that the contents are as described in the delivery document(s) and are not dam-
aged.
If anything is missing, damaged, or not as described by the packing list, contact Kontron
for further instructions. Do not proceed until notified by Kontron.
3. Dispose of the packaging material as appropriate.
Warning!
The ThinkIO-P itself is delivered as a closed unit and must not be opened.
In particular, if the ThinkIO-P is provided with a WAGO interface module
(K-Bus) attached to it, the interface module is not removable. Except for
the backup battery which is accessible from the front, there are no user servi-
cable parts within the ThinkIO-P or WAGO interface module (K-Bus). Open-
ing or removing of any attached components except for the battery will void
the product warranty.
1.6

Mounting

The ThinkIO-P is designed to be mounted on a securely fixed, grounded, top-hat DIN rail for
operation. If for any reason that this is not possible, it must be ensured that the ThinkIO-P is
placed on a secure, flat, level surface with ESD protection before being operated.
Kontron assumes no liability for any damage whatsoever resulting from the operation of an un-
securely fixed ThinkIO-P.
1.7

Software and Documentation

The ThinkIO-P is delivered initially with pre-installed software. This is to ensure that it may be
operated for application installation or development. In addition, software and product docu-
mentation are provided on accompanying CD-ROMs.
Page 2
QUICK START GUIDE QUICK START GUIDE QUICK START GUIDE
© 2005 Kontron Modular Computers GmbH
ThinkIO ThinkIO ThinkIO - P - P - P
™ ™ ™
ID 29867.01, Rev. 01