Power Requirements; Installation Of The Thinkio-P - Kontron ThinkIO-P Quick Start Manual

Pre-Operation
Before applying power to the ThinkIO-P, all interfacing cabling must be connected and, if re-
quired, the WAGO-I/O-SYSTEM 750/753 modules must be installed and their interfacing ca-
bling connected.
Warning!
If the ThinkIO-P is to be operated with a CompactFlash card installed, it must
be installed before applying power to the system. The CompactFlash inter-
face is not a "hot plug" interface. In addition, do not remove the Compact-
Flash card with power applied to the system.
Failure to comply with this directive can result in damage to the Compact-
Flash card, and will result in improper operation of the system.
2.2

Power Requirements

The ThinkIO-P itself requires 24 V DC for operation. This is supplied via the X4 connector.
The optional WAGO-I/O-SYSTEM 750/753 modules have their own power input connections.
Refer to appropriate WAGO module documentation for the exact power and wiring connection
requirements.
Availability of appropriate power sources must be ensured prior to installation.
Note...
The ThinkIO-P provides 5 VDC internal system power for the WAGO I/O
modules (excluding the WAGO interface module (K-Bus)) up to a maximum
of 1 A of current. If more power is required for I/O modules, one or more
WAGO Internal System Supply modules (750-613) must be added as appro-
priate to provide additional module power.
2.3

Installation of the ThinkIO-P

Using the application requirements as a guide, assemble the ThinkIO-P and the associated ap-
plication components. To achieve this, perform the following:
1. Mount the ThinkIO-P on the DIN rail or place on an appropriate surface.
2. If WAGO I/O modules are to be installed, refer to WAGO documentation for their assem-
bly.
3. Ensuring that no power is applied, connect all interfacing cables.
Note...
If any connector protection caps were removed to install interfacing cables,
retain these caps for future use. They are special ESD protection devices for
the connectors on which they were installed, and they are required to be
installed if the connector is not used.
4. Verify the physical configuration with the application requirements. Resolve any anoma-
lies before proceeding.
Page 4
QUICK START GUIDE QUICK START GUIDE QUICK START GUIDE
© 2005 Kontron Modular Computers GmbH
ThinkIO ThinkIO ThinkIO - P - P - P
™ ™ ™
ID 29867.01, Rev. 01