Two Discrete Lengths (Parameter L2); Length Within Range; Any Length - Honeywell Marathon Programming Manual

Two Discrete Lengths (Parameter L2)

This option decodes only those codes containing two selected lengths. For example, when you want to scan only I 2 of
5 symbols containing 2 or 14 characters, scan the "I 2 of 5 Two Discrete Lengths" bar code and then "0", "2", "1" and "4"
bar codes using the "Imager Keypad Number Symbols". Default = 14.
To begin setting two discrete lengths, scan this I 2 of 5 Two Discrete Lengths bar code:
Next, scan four numeric bar codes that correspond to the desired value. Single digit numbers must have a leading
zero. To correct an error or to change a selection, scan Cancel on the "Imager Keypad Number Symbols" page.

Length Within Range

This option decodes a code type within a specified minimum and maximum range. For example, when you want to
scan only I 2 of 5 symbols containing between 4 and 12 characters, scan the "I 2 of 5 Length Within Range" bar code
and then "0", "4", "1" and "2" bar codes using the "Imager Keypad Number Symbols".
To begin setting lengths within a range, scan this I 2 of 5 Length within Range bar code:
Next, scan numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero. To
correct an error or to change a selection, scan Cancel on the "Imager Keypad Number Symbols" page.

Any Length

This option decodes I 2 of 5 bar codes containing any number of characters.
Note: Selecting this option may lead to misdecodes for I 2 of 5 codes.
To set any length, scan this I 2 of 5 Any Length bar code:
2 - 55