Upc/Ean/Jan Supplemental Redundancy; Transmit Upc-A Check Digit - Honeywell Marathon Programming Manual

Hide thumbs Also See for Marathon:

Table of Contents

UPC/EAN/JAN Supplemental Redundancy

With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times a symbol without

supplementals is decoded before transmission. The range is from 2 to 30 times. Five or above is recommended when

decoding a mix of UPC/EAN/JAN symbols with and without supplementals, and the autodiscriminate option is selected.

Default = 10 Times.

To begin setting the decode redundancy value, scan this bar code:

Next, scan two numeric bar codes that correspond to the desired value using the

digit numbers must have a leading zero.

To correct an error or change a selection, scan Cancel on the Imager Keypad Number Symbols page.

This parameter determines whether the symbol will be transmitted with or without the UPC-A check digit.

Select an option by scanning either of the bar codes shown below.

* Enable Transmit UPC-A Check Digit

Disable Transmit UPC-A Check Digit

2 - 34

Imager Keypad Number

Symbols. Single

Table of Contents

Show Quick Links

Table of Contents