Two Discrete Lengths (Parameter L2); Length Within Range; Any Length - Honeywell Marathon Programming Manual

Two Discrete Lengths (Parameter L2)

This option decodes only those codes containing two selected lengths. For example, when you want to scan only Code
11 symbols containing 2 or 14 characters, scan the Code 11 Two Discrete Lengths bar code and then "0", "2", "1" and
"4" bar codes using the Imager Keypad Number Symbols. Default = 55.
To begin setting two discrete lengths, scan this Code 11 Two Discrete Lengths bar code:
Next, scan four numeric bar codes that correspond to the desired value. Single digit numbers must have a leading
zero. To correct an error or to change a selection, scan Cancel on the "Imager Keypad Number Symbols" page.

Length Within Range

This option decodes a code type within a specified minimum and maximum range. For example, when you want to
scan only Code 11 symbols containing between 4 and 12 characters, scan the "Code 11 Length Within Range" bar
code and then "0", "4", "1" and "2" bar codes.
To begin setting lengths within a range, scan this Code 11 Length Within Range bar code:
Next, scan numeric bar codes that correspond to the desired value using the Imager Keypad Number Symbols. Single
digit numbers must have a leading zero. To correct an error or to change a selection, scan Cancel on the "Imager
Keypad Number Symbols" page.

Any Length

This option decodes Code 11 bar codes containing any number of characters.
To set any length, scan this Code 11 Any Length bar code:
2 - 51