Error/Warning Messages - Sony MKS-R4020 Operating Instructions Manual

Error/Warning Messages

If trouble occurs on the unit, the status lamp lights in red
and an error/warning message is displayed on the STATUS
button.
Error messages
Message Description
PIF FPGA Err The PIF FPGA is not operating.
PIF DDR Err The PIF DDR SDRAM is not operating.
KY FPGA Err The KY FPGA is not operating.
PIF Recovery The PIF FPGA started in recovery mode.
High Temper The temperature exceeds the rated range.
KY Recovery The KY FPGA started in recovery mode.
KY Unknown The KY board model name is unknown.
SW Recovery The software started in recovery mode.
Network Linkdown Non-redundancy mode: The LAN1 link is down.
Redundancy mode: The LAN1/LAN2 links are down.
DHCP Srv Lost Non-redundancy mode: The lease file of LAN1 does
not exist.
Redundancy mode: The lease files of both LAN1/LAN2
do not exist.
Sys Comm Err Non-redundancy mode: Connection with the system
controller was lost in a Primary connection.
Redundancy mode: Connection with both system
controllers was lost in a Primary/Secondary
connection.
PanelCnf Err A configuration error occurred.
DHCPConf Err Non-redundancy mode: The required information
from the lease file of LAN1 could not be loaded.
Redundancy mode: The required information from
the lease files of both LAN1/LAN2 could not be
loaded.
Warning messages disappear after being displayed for
about 2 seconds.
Solution
Check the hardware.
Check the hardware.
Check the hardware.
Check the hardware.
Check the installation environment.
Check the hardware.
Check the hardware.
Check the hardware.
Check the network settings and connections.
Check the network settings and connections.
Check the network settings and connections. Also,
check that the date and time are set correctly.
Reset the settings or load a user settings status file.
Check the network settings and connections.
23