Honeywell AlarmNet GSMHS Installation And Setup Manual page 40

GSMHS Installation and Setup Guide
[T]
[X]
[]
(UP arrow)
[]
(DN arrow)
[0]
[ENTER]
5-4
Line Voltage
xx.xxV
Test Msg Sent
Reset CPU Y/N
Registering ...
Enter PIN#
Force Server Update?
Y/N
Strt Prog Mode?
Y/N_
Line Voltage Display
The line voltage of the GSMHS can be viewed on the
7720P. An asterisk (*) next to the voltage indicates
that this is below the accepted level.
Press the [Space] key to go back to the System Status
Display.
Press the backspace [BS] key to go to the previous field.
Test Alarm
Sends a Test alarm to AlarmNet. Functional for a
registered GSMHS only. If the device is not registered,
a message is displayed indicating that the command
cannot be executed.
NOTE: If two CSIP's are used, test alarms are sent to
each central station. In addition, if the primary fails to
report, a second (backup) message is sent to the
secondary station.
Reset the GSMHS.
Pressing [N] returns to normal mode.
Pressing [Y] resets the device.
Registration
Registers a programmed GSMHS with AlarmNet.
Registration with PIN for Replacement Module
Registers a replacement GSMHS with AlarmNet, once
programmed, using the existing PIN #.
Force Upload of Configuration File to Server
Pressing [Y] will force the device to upload its entire
configuration file to the server.
Pressing [N] cancels the operation.
NOTE: If the GSM module is not initialized when you
enter this command, the following screen will be
displayed:
Cannot Upload
Try Later! _
Wait for the RSSI LEDs to light, indicating the GSM
module has completed its initialization, and try again.
Enter Program Mode
Press [Y] to enter program mode; otherwise, press [N].