Table of Contents
Advertisement
GSMHS Installation and Setup Guide
PROMPTS
53
Restore Zn6 Y/N
(Y)_
Delay Zn6 (secs)
54
(00)_
Rpt Zn6 ONLY if
55
Armed (N)_
Enable Zn7 Y/N
56
(N)_
Zn7 Trigger Type
57
(V+)_
Invert Zn7 Y/N
58
(N)_
Restore Zn7 Y/N
59
(Y)_
60
Delay Zn7 (secs)
(00)_
Rpt Zn7 ONLY if
61
Armed (N)_
Restore Zn8 Y/N
62
(Y)_
Delay Zn8 (secs)
63
(00)_
3-16
4204/
ZONE
ENTRY
2-4204
TRIG.
4204
only
4204
only
4204
only
2-
4204
only
2-
4204
only
OPTIONS
[Y], [N]
Enables restore reporting for zone 6.
UL: Must be set to "Y."
[01-15]
Defines the reporting delay in seconds for
zone 6.
[00] = no
UL: Must be set to "00."
delay
[Y], [N]
Reports alarms on zone 6 ONLY if the
conditional zone (zone 7 in zone trigger mode;
zone 4 in 4204 mode; zone 8 in 2-4204 mode) is
triggered (armed).
If [N], always reports alarms on zone 6.
[Y], [N]
Enables alarm reporting for zone 7, if used.
If [N], skip to Prompt 64: "Review."
(EOLR)
Selects the triggering method for this zone
(V+)
input.
(V–)
Press the [space] key to scroll through choices.
[Y], [N]
Inverts the alarm and normal states of the
zone 7 trigger; otherwise uses normal input
signal.
Enables restore reporting for zone 7.
[Y], [N]
Zone Trigger mode: This question will only
be displayed if zone 7 is not used as the
conditional (arming) trigger zone.
UL: Must be set to "Y."
[01-15]
Defines the reporting delay in seconds for
zone 7.
[00] = no
Zone Trigger mode: This question will only
delay
be displayed if zone 7 is not used as the
conditional (arming) trigger zone.
UL: Must be set to "00."
[Y], [N]
Reports alarms on zone 7 ONLY if the
conditional zone (zone 4 in 4204 mode; zone 8
in 2-4204 mode) is triggered (armed).
If [N], always reports alarms on zone 7.
2-4204 mode: If any zone is programmed to
"Report Only if Armed," or if tamper is
enabled, skip to "Review."
[Y], [N]
Enables restore reporting for zone 8.
UL: Must be set to "Y."
[01-15]
Defines the reporting delay in seconds for
zone 8.
[00] = no
delay
UL: Must be set to "00."
DESCRIPTION
Advertisement
Table of Contents
