Configuring The Door Opener Time - Telecom Behnke myintercom Plus Instructions Manual

myintercom Plus IP video door intercom Instructions
GB
Card reader
Deleting the transponder
Hold the master card in front of the card
reader and select the required memory loca-
tion (see "4.1. Selecting the memory location"
on page 61).
The memory location is allocated if the right-
hand decimal point lights up.
Now remove the master card from the card
reader. The memory location lights up contin-
uously for approx. 3 seconds and then flashes
for approx. 6 seconds. Hold the transponder
in front of the card reader again, while the
display flashes.
The memory location is now deleted and the
right-hand decimal point is no longer lit.
62

4.3. Configuring the door opener time

The user can set the door opener time at
between 0.5 seconds to 9 seconds. A hold
time of 4 seconds is set in the factory.
Hold the master card in front of the card
reader. The memory locations are counted off
up to 190 (" "). The following display then
1.9
appears:
The door opener times then appear one after
the other.
= 0.5 seconds
H0
= 1 second
H1
...
= 9 seconds
H9
Remove the master card at the required time.
The display lights up continuously for approx.
3 seconds and then flashes for approx. 6
seconds.
www.behnke-online.de