Setting The Door Gong - Telecom Behnke myintercom Plus Instructions Manual

myintercom Plus IP video door intercom Instructions
GB
Installation
The door gongs are connected to the terminals
marked "Gong". Button 1 switches gong 1,
button 2 switches gong 2, ... The buttons are
numbered from the top down.
Important! The housing cover must be
screwed back on again in order for the tamper
protection to work!
56

2.4. Setting the door gong

You can set the number of gong strokes
triggered each time the button at the door
station is pressed. In the basic setting the
station switches the gong on and off twice
Gong 1
(provided
when the button is pressed (switch position
by the
2). The number can be set between zero and
customer)
nine with the help of a rotary switch on the
Bell transformer
(provided by the
door station's electronics. In switch position
customer)
zero the gong does not sound, instead a push
message appears at the terminal device.
To set the rotary switch, please remove the
housing cover and set the switch to the
required number.
Important! The housing cover must be
screwed back on again in order for the tamper
protection to work!
www.behnke-online.de