Chapter 4: Serial or Telnet I/O Functions
4.4.28
F100 PLS - Password Lock Set
Use Password Lock Set to lockout setting of passwords via Telnet.
To inhibit password changes, send the following command:
The unit responds:
If you answer "y" and press Enter, the unit executes the command.
As a safety feature, after sending this command, you have 10 seconds to respond
affirmatively (enter the letter "y") to the confirmation prompt, after which the unit
executes the command and resets. Within that 10 second time period, any other response,
including no response, results in the unit canceling the command.
Unit example execution:
4.4.29
F100 PLR - Password Lock Reset
Use Password Lock Reset to allow setting of passwords via Telnet.
To allow password changes, send the following command:
The unit responds:
If you answer "y" and press Enter, the unit executes the command.
As a safety feature, after sending this command, you have 10 seconds to respond
affirmatively (enter the letter "y") to the confirmation prompt, after which the unit
executes the command and resets. Within that 10 second time period, any other response,
including no response, results in the unit canceling the command.
Unit example execution:
4.4.30
F100 PE LIST - Peer List Request
Use Peer List to view the NTP peers being polled every 64 seconds.
To display the peers, send the following command:
An example unit response:
4-84
F100 PLS<Enter>
Are you sure? (y/N)
PASSWORD_SETTING_DISABLE_BIT = 1
F100 PLR<Enter>
Are you sure? (y/N)
PASSWORD_SETTING_DISABLE_BIT = 0
F100 PE LIST<Enter>
Peer no: 001 127.127.001.000
Peer no: 002 206.254.000.020
TimeVault™ User's Manual
Extended Function Commands
6000-100Ch4.fm Rev. D