F100 St - Self Test Status - Symmetricom Time Server User Manual

Extended Function Commands
change the user name and password to whatever you want. Then you can go back into
normal mode the and the user name and password you just set will work.
4.4.9 F100 ST – Self Test Status
Use Self Test Status to query the status of the power-up tests. The response contains the
PASS/FAIL status of the flash memory checksum test, RAM test, Utility Port test, and
version check.
To query the self-test status, send the following command:
where:
The unit responds:
where:
An example of the response is:
6000-100Ch4.fm Rev. D
F100<SP>ST<Enter>
F =
100 =
<SP> =
ST =
<Enter> =
F100<SP>ST<SP>FLASH/CRC<SP>:<SP><STATUS>,<SP>RAM<SP>:
<SP><STATUS>,<SP>SERIAL<SP>:<SP><STATUS>,<SP>VER<SP>:
<SP><STATUS><CR><LF>
F =
100 =
<SP> =
ST =
FLASH/CRC =
RAM =
SERIAL =
VER =
<STATUS> =
, =
: =
<CR><LF> =
F100 ST flash/CRC : PASS, Ram : PASS, Serial : PASS, Ver :
PASS<CR><LF>
TimeVault™ User's Manual
Chapter 4: Serial or Telnet I/O Functions
ASCII character F
unit function number
space
specify ST command
input line terminator
ASCII character F
unit function number
space
specify ST command
specify flash checksum result
specify RAM test result
specify Utility Port test result.
specify version test result. This test compares the
version of the code against the version recorded in
Non-Volatile memory
is either ASCII PASS or FAIL
ASCII comma
ASCII colon
output line terminator
4-65