Command List - Symmetricom Time Server User Manual

Symmetricom time server user's manual
Table of Contents

Advertisement

Command List

Command List
4.2
The following table lists all serial/Telnet commands that are used to operate, administer,
and maintain the unit. The Utility Port is ready to receive these commands once the
power-up sequence is complete. The F100 series is used mainly to request or set unit NET
Port parameters. Configuration of the IP Address, Subnet Mask, Default Gateway, and
DHCP parameters is also available through the front panel keypad. Changing any
network parameter causes the unit to reboot.
Use the front panel keypad to set initial system configuration values at first installation.
Command
F03
F18
F36
F53
F60
F67
F72
F100 BASET
F100 DHCP
F100 EA
F100 IP
F100 SM
F100 G
F100 IC
F100 P
F100 ST
F100 VER
F100 T
F100 CONFIG
F100 LOCK
F100 L
6000-100Ch4.fm Rev. D
Table 4-1: F-Series Function Commands
Function
Time/Date Request
Software Version Request
Network Configuration Entry/Request
Operating Mode Request
Satellite List Request
Leap Second Information Request
Fault Status Request
100Base-T/10Base-T Entry/Request
DHCP Control
Ethernet Address
IP Address
Subnet Mask
Default Gateway
Network Configuration Request
Password Change Request
Self Test Results Request
Software Version Request
Request Current Time Source
NTP, SNMP and ACTS Configuration
Remote Lockout
Lock Display Request
TimeVault™ User's Manual
Chapter 4: Serial or Telnet I/O Functions
Parameters
MM/DD/YYYYHH:MM:SS
(equivalent to F100 VER)
EA, IP, SM, G
(equivalent to corresponding F100 commands)
10, 100
(change requires confirmation within 10 seconds)
ENABLE/DISABLE
(change requires confirmation within 10 seconds)
### ### ### ###
(change requires confirmation within 10 seconds)
### ### ### ###
(change requires confirmation within 10 seconds)
#### #### #### ####
(change requires confirmation within 10 seconds)
IP, SM, G
XXXXXXX
GPS, ACTS, or NTP
"GET" , "SET", "NTP", "SNMP", "ACTS", "IP
ADDRESS", "YES", "NO", "W", "R"
(change requires confirmation within 10 seconds)
LOCK
(change requires confirmation within 10 seconds)
4-51

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents