Symmetricom Time Server User Manual page 49

Web Access
where:
3. Edit the file.
4. Press
<Enter>
TimeVault takes a moment to reset, during which time the parameter display goes
blank. When TimeVault starts up again, the new parameters are in place. If the unit
does not reset, check the status message to see why, re-enter the values, then click
Submit Changes again.
6000-100Ch3.fm Rev. D
number =
line =
inter =
type =
retry =
timeout =
duration =
delay =
period =
flag =
speed =
fudge =
pollcounter =
center =
modemInit =
or click Submit Changes just below the display of parameter values.
TimeVault™ User's Manual
the ACTS telephone number, including area code;
this example shows the NIST service in Boulder,
CO, U.S.A.
access digit for an outside dial tone
prefix for international and long distance service (up
to 9-digits)
tone or pulse dialing
number of times the modem tries to reach ACTS
after sending a command to the modem, the time
interval, in seconds, that TimeVault waits for a
modem response before timing out
duration, in seconds, of a single ACTS session,
starting after the modem detects a carrier
reserved for factory calibration only; do not change
time interval, in minutes, between call attempts
set to ON by default; do not change
baud rate, set to 9600 by default; reserved for
factory calibration only; do not change
reserved for factory calibration only; do not change
determines time precision vs. risk of unsuccessful
call; reserved for factory calibration only; do not
change
calibration of the phone line; reserved for factory
calibration only; do not change
modem initialization string; reserved for factory
calibration only; do not change
Chapter 3: Remote Operation
3-35