F100 Ic - Net Port Network Configuration Entry/Request; F100 P - Change User Password - Symmetricom Time Server User Manual

Chapter 4: Serial or Telnet I/O Functions
4.4.7 F100 IC – NET Port Network Configuration Entry/Request
To review the entire NET Port network configuration, send the following command:
An example of the response is:
where N:E denotes Ethernet DIX.
4.4.8 F100 P – Change User Password
If you want to change a password, you must log in as the user for whom you want to
change the password (also see page 4-86). The maximum password size is ten characters.
To change the user password, send the following command:
where:
The unit responds:
When you enter a new password, the unit responds with:
Enter the same new password again, to confirm the spelling. If the same new
password has been entered twice, the unit responds with:
In this case, the new password will be used for the next login (serial or Telnet).
However, if the new password is entered differently the second time, the unit responds
with:
In this case, the old password will be used for the next login (serial or Telnet).
If you have forgotten your user name and/or password, you can go into bootloader
mode and reset them. In bootloader mode the unit recognizes the default user name
and password. You can then use F100 PR (see page 4-83) or F100 PRESETALL (see
page 4-82) to change the user name and password to defaults for use in the normal
mode, or you can use F100 PN (see page 4-82) and F100 P (the above command) to
4-64
F100<SP>IC<Enter>
F100 IP:206.54.0.21 SM:255.255.255.240
G:206.54.0.17N:E<CR><LF>
F100<SP>P<Enter>
F =
100 =
<SP> =
P =
<Enter> =
Enter new user password:
Enter it again:
OK<CR><LF>
ERROR: Passwords do NOT match.
ASCII character F
unit function number
space
specify Password command
input line terminator
New password rejected.
TimeVault™ User's Manual
Extended Function Commands
6000-100Ch4.fm Rev. D