Mastervolt CombiMaster 12V/2000W 100A User And Installation Manual page 25

For more information, please refer to the CZone
Also see section 5.2. for a description of the same settings in MasterAdjust.
CombiMaster 120V Series – User and Installation Manual
®
10. Check and adjust the AC settings.
In Energy Save Mode the power
consumption will be reduced when
there is no load on AC OUT. Please
note that small loads, such as the
clock on a microwave oven, are most
likely not to work in this mode.
See section 3.2 for a description of
AC IN Support.
For a description of instances and
PGNs, please refer to the CZone
Configuration Tool Instruction
manual.
11. Press OK to return to the Advanced
Settings window.
12. Check and adjust the DC settings.
13. Press OK to return to the Advanced
Settings window
14. Select the required Alarm Severities.
15. Press OK.
Optionally configure digital switching by
adding Circuit Controls in the Circuits tab
(e.g. a battery low switch can be used to
start a generator). Write the configuration
to the network to use the new
configuration.
Configuration Tool Instruction manual.
25