System Integration (Czone/Masterbus) - Mastervolt CombiMaster 12V/2000W 100A User And Installation Manual

18
CombiMaster 120V Series – User and Installation Manual
4.9

System integration (CZone/MasterBus)

The CombiMaster Inverter/Charger can be connected to a CZone or MasterBus network.
•
CZone network
Points to consider:
˗
Up to 40 devices can be connected together on a single backbone.
˗
Make sure the CZone network has two terminating resistors, one at each open end of the
backbone.
˗
The electric power for the network comes from a battery or power supply. Make sure that it
delivers enough power and is positioned as close to the middle of the backbone run as possible
to reduce voltage drop.
˗
Each device on the CZone network has a unique CZone address; the Dipswitch. This number is
usually assigned automatically during configuration and must match the DIP switch settings.
This is done in the CZone Configuration Tool.
•
MasterBus network
Use an RJ45 MasterBus cable (not included) and daisy chain the CombiMaster Inverter/Charger to
the other MasterBus devices, forming a local data network.
Points to consider:
˗
Connections between the devices are made by standard MasterBus cables. Mastervolt can
supply these cables.
˗
Up to 63 MasterBus devices can be connected together.
˗
MasterBus needs a terminating device on both ends of the network.
˗
The electric power for the network comes from the connected devices according to the rule:
1powering / 3 non-powering. Spread the powering devices over the network
˗
Do not make ring networks.
˗
Do not make T-connections in the network.
CAUTION!
Never connect a non-MasterBus device to the MasterBus network directly! This will
void warranty of all MasterBus devices connected.
For more details on networks, please contact your Mastervolt supplier.