User Management; Lock Setup; Setup With Dallas Key; Setup With Pc - Tecnosicurezza MiniTech User Instructions

User instructions

User management

Power up the keypad. Press and hold
Enter Manager code.
Press to scroll users list or enter user ID.
" " user installed, "_" user deleted, "X" user disabled.
Override users 50 ÷ 59 can be only installed when the lock is open.
Press . If the user is not installed LCD shows the message:
" " Dallas key, " " code, "+" dual mode, "TL" time lock
Press to confirm or
Enter the new user code and confirm it.
If the selected user is already installed, press
to disable it, to delete it or for leaving and selecting another user. Press
to confirm the choice.

Lock setup

Lock setup can be performed through a Dallas key properly programmed or through a direct
PC link. In both cases, lock must be in pre-setup mode (press 1 to open it).

Setup with Dallas key

Power up the keypad. Press and hold
Insert the setup Dallas key in the reader and connect the reader with
the keypad by means of the jack connector. LCD shows:
Check time and date. Press
Then press again to confirm. LCD shows:
If the operation is successfully performed, LCD shows:

Setup with PC

Power up the keypad. Press and hold
10 di 22
. LCD shows:
to exit or for switching to the next user.
. LCD shows:
to confirm or to update the values.
. LCD shows:
to choose whether
MiniTech
USERS MANAGEMENT
0 1 – X X X X X X
02 03 04 05 06
x _ _ ✓
✓
02
INSTALL?
SYSTEM SETUP
08:00 FRI
27/01/2019
UPLOADING 10%
OPERATION DONE
PC LINK
IU_ MiniTech_04