Opening With Dynamic Codes; Block And Unblock The Lock - Tecnosicurezza MiniTech User Instructions

MiniTech
Press , LCD shows:
Start the programming on the Setup software or press
If the operation is successfully performed, LCD shows the firmware
version and few seconds later the keypad switches OFF. Pease refer
to the user manual IU_Minitech_setup_XX for further information.

Opening with dynamic codes

Power up the keypad and insert the Dallas dynamic key in the Dallas
reader. Alternatively, press and hold
PIN (optional). LCD shows:
Enter the dynamic user PIN. LCD shows:
Enter the dynamic code and press
Open the lock within 3 seconds (green led ON).
If set by the software Dyama or Dyamaweb for dynamic codes creation,
LCD shows the closing code when the bolt re-closes. Please refer to the
user manuals IU_Dyama_XX or IU_DyamaWeb_XX for further
information.

Block and unblock the lock

Power up the keypad. Press and hold
Enter the requested code.
If a weekly time lock is already scheduled, LCD shows the next opening
time.
To set a different opening time, enter the new values (max. 31 days)
and then press to confirm.
LCD shows:
Press to confirm. LCD will display the message:
IU_MiniTech_04
to exit.
to enter the dynamic user
.
. LCD shows:
User instructions
PC LINK
...
DYNAMIC USER
X X X X
DYNAMIC CODE
X X X X X X X X X
CLOSING CODE
179
BLOCK SYSTEM
X X – X X X X X X
BLOCK UNTIL
14/09 08:00
BLOCK UNTIL:
DD/MM hh:mm
BLOCK THE
LOCK?
LOCK BLOCKED
11 di 22