Messages And Instructions On The Display; Acknowledge Message; Error Messages - Fasel Elektronik FCU6x00 Series Installation And Operating Manual

Sauna control units
Table of Contents

Advertisement

8.2

Messages and instructions on the display

Messages and instructions may be shown on the display that require the operator to
take action.
Messag-
Possible causes
es/Instruction
s
Device not re-
Sauna control unit is
sponding
switched off.
Connection to
1. No server connection
the server
with the App.
failed
2. No server connection of
the Connect Box.
USB
USB connection interrupted
NOT EXISTS
Water
Evaporator without water
deficiency
Drying function
After completion of the
"Sauna with humidity" bath
interrupted
mode, the cabin is auto-
matically dried for a defined
period and at a defined
temperature. This drying
function helps to avoid
damage to the cabin, e.g.
mould growth. This drying
function was interrupted
prematurely.
Table 8: Messages and instructions
8.3

Acknowledge message

1.
2.
8.4

Error messages

This section describes possible faults and troubleshooting measures.
Contact the installer or dealer for your sauna system in the event of faults that cannot
be dealt with based on the following descriptions. Refer to the invoice, delivery note or
the back of this manual for the address.
Installation and Operating Manual / Version V 1.02
Eliminate the cause of the error.
-Press the key for approx. 2 seconds. Message disappears.
Measures
Switch on the sauna control unit.
1. Check the Internet connection on
your Smartphone/Tablet
2. Restart the Connect Box and wait for
about 5 minutes until the connection to
the server is established.
Pay attention to the beep confirmation.
Check if the USB cable between FCU
and Connect Box is plugged in.
Restart the Connect Box and wait for
about 5 minutes until the connection to
the server is established.
Pay attention to the beep confirmation.
Fill water according to the operating
manual of the evaporator.
Check water inlet / magnetic valve on
the evaporator.
Follow the instructions on the display:
Restart the drying function
Cancel the drying function
Faults
To be carried
out by
Operator
Operator
Operator
Operator
Specialist/
electrician
Operator
27

Advertisement

Table of Contents
loading

Table of Contents