Table of Contents
Advertisement
Connection and initial set-up by service technician
3.4
Initial set-up with WLAN operation
During initial operation, the Connect Box must be connected to the existing WLAN.
1.
2. Please connect to the WLAN "CONNECT-BOX".
3. On your Smartphone/Tablet, open the Internet browser (e.g., Safari or Chrome) and
4. Select your own home WLAN from the list and enter your personal WLAN password.
5. After saving the settings successfully, the Connect Box automatically connects to
14
NOTE!
Please have your personal WLAN password ready for set-up via WLAN.
Start the Connect Box by briefly disconnecting it from the power supply and plug-
ging it in again.
After it is switched on, the Connect Box searches for all available WLAN connec-
tions. The Connect Box then opens its own WLAN "CONNECT-BOX".
Note: This WLAN is only required for setting the Connect Box. It is only available
for 3 minutes once the "Connect Box" has been found by your Smartphone/Tablet.
Please perform the following steps (2-5) within these 3 minutes.
To do this, open the WLAN menu in your Smartphone/Tablet:
Settings WLAN Search WLAN
Connect to "CONNECT-BOX"
The password required for this is: "11111111"
Note: This WLAN does not have Internet access. Any warnings that your
Smartphone/Tablet is not connected to the Internet can be ignored or, if you are
prompted to do so, this message must be confirmed.
Note: Check that you are still connected to the WLAN "CONNECT-BOX".
Note: After a repeated connection with "CONNECT-BOX", the password may be
saved and does not have to be entered again.
open the following page in the address bar: "http://10.42.0.1"
Then press "Save & Restart".
If your WLAN is not listed, check the WLAN signal strength!
After saving you lose the connection to the Connect Box, which can lead to an error
message in your browser.
Note: Remember to reconnect your Smartphone/Tablet to your home WLAN.
your in-house WLAN and afterwards to the cloud server.
The sauna control unit gives the following feedback signals on these three process-
es via the buzzer:
1x beep: Settings saved.
Note: If this 1x beep is not heard, you may have taken too long or are too far away
from the Connect Box. In this case, you must start again from step 1.
2 x beeps: WLAN connection successfully established.
Note: If the 2x beeps are not heard, the Connect Box has not connected to your in-
house WLAN. You may not have enough WLAN reception or a wrong WLAN pass-
word. You may need to move the Connect Box to another location. Please check
both and start again at step 1.
Installation and Operating Manual / Version V 1.02
Advertisement
Table of Contents
