Table of Contents
Advertisement
6.2
Switching the sauna control unit on and off
6.2.1
Switching on the sauna control unit
Ensure that the oven, its immediate surroundings and the sensors are free of objects.
1.
2.
3.
6.2.2
Switching off the sauna control unit
Installation and Operating Manual / Version V 1.02
NOTE!
The temperature and humidity readings shown on the thermometers and
hygrometers installed additionally in the cabin may differ from those on the
control unit. This may have the following reasons:
Temperature differences of between 60K and variance in humidity of up to
40% may be encountered from the floor to the ceiling or between the oven
and the opposite wall, depending on the cabin
Instruments with pointers do not respond as sensitively, compared to the
electronic measurement and display system used in the control unit.
Use the "Control unit standby" key to switch on the sauna control unit.
See page 18.
Select bath mode on the display (see Table 2).
To start the bath mode, press and hold the bath mode key until the key lights up
orange (see Table 2).
WARNING!
Repeated improper shutdown can lead to premature damage to elec-
tronic parts.
For this reason:
– Switch off sauna control unit as described.
WARNING!
Cabin damage, e.g. mould growth due to premature ending of the
drying function.
After completion of the "Sauna with humidity" bath mode, the cabin is au-
tomatically dried for a defined period and at a defined temperature. This
drying function helps to avoid damage to the cabin, e.g. mould growth.
For this reason:
– Do not end drying function prematurely.
– The drying function may only be ended if the cabin is operated after-
wards in the "Sauna" bath mode.
– A message appears on the screen if the drying function has been acci-
dentally stopped. Follow the instructions on the display to restart the
drying function.
Operation
21
Advertisement
Table of Contents
