Checking The Electrical Connection; Commissioning; Safety Instructions - Fasel Elektronik FNT2000 Series Installation Instructions Manual

Sauna control
Table of Contents

Advertisement

Commissioning

5.5

Checking the electrical connection

After the sauna control device and the sensor are electrically connected the following
points should be checked:
Commissioning
6
6.1

Safety instructions

Electric poten-
tial
22
Does the voltage supply match the specifications on the nameplate?
Have the cable specifications given in Table 2, page 10 and the electrical circuit dia-
gram Figure 18, page 30 been followed?
Is the control device connected according to the electrical circuit diagram?
Are the sensors (temperature and humidity) connected correctly?
DANGER!
Danger to life due to electric potential!
Contact with live components can be fatal.
Damage of the insulation of the individual components can be danger-
ous to life.
Therefore:
For switching off the mains, the power supply cable must be equipped
with a fuse with a contact opening width corresponding to the require-
ments of the excess voltage category III for total disconnection.
Disconnect the unit from the mains before carrying out any work on it
(switch off the fuse in the distribution box) and secure against restarting.
Check for zero potential. The control device should be disconnected
from the mains before opening the casing.
– In case of damage to the insulation, switch off the power supply im-
mediately and carry out the repair.
– Work on electrical unit should be carried out by certified electricians
only.
– Never bypass fuses or put them out of operation.
– While replacing fuses, pay attention to correct current specifications.
– Keep moisture away from live components, since it can lead to short
circuit.
WARNING!
If a short circuit occurs in a 230V/400V load, the relay contact can
be welded by the high short-circuit current. Is turned on before
removing the short circuit, the safety relay can be also welded.
This can lead to the continuous operation of the load. Turn off the
circuit breaker in the junction box. Send the unit back to the
factory for check/repair.
Installation instructions

Advertisement

Table of Contents
loading

Table of Contents