Setting Modem Card Configurations; Working With The Hardware In The System Unit - IBM Aptiva Series Handbook

Setting modem card
configurations
If your system is equipped with a modem, follow these steps
to view or change I/O addresses and interrupt request
resources for a port on an installed modem card:
1.
Right click on the "My Computer" icon and select
.
Properties
2.
In the System Properties window, click on the
tab.
Manager
3.
Click on
View devices by type
4.
Double-click on the modem list item to expand the list
underneath this item.
5.
Double-click on the
LT Win Modem
the expanded list.
6.
In the LT Win Modem or Modem
click on the
Resources
If you need help in using the Device Manager, press the
key to view the online help.
You must restart your computer before any Device Manager
changes can take effect.
7-2 Chapter 7: Adding and removing adapter cards and drives
Device
.
or item in
Modem
window,
Properties
tab.
Working with the hardware in the
system unit
If you have not removed the cover from your system unit,
see "Opening the system unit" on page 6-4.
If you plan to add both an adapter card and a drive, install or
replace the drive before you install or replace the adapter
card. If you also plan to make hardware changes on the
system board, see Chapter 8 and finish your work with the
system board before continuing to work with the drives and
adapter cards.
To add or remove adapter cards or drives in the system unit,
complete the instructions in the following sections:
"Adding and removing adapter cards" on page 7-3
"Adding and removing drives" on page 7-5
F1