IBM Aptiva Series Handbook page 24

Part 3: Controlling system settings
This part contains information to help you configure or
reconfigure the hardware and hardware features that were
installed in your computer at the factory. It includes the
following chapters:
"Chapter 3: Getting started with your Aptiva computer"
on page 3-1
This chapter contains instructions for making
adjustments to the monitor and the system volume
settings on your Aptiva computer. It also provides
information to help you connect your computer to a
printer or to the Internet.
"Chapter 4: Power management features" on page 4-1
This chapter describes the software shutdown and
suspend features of your Aptiva computer for more
efficient power management. It also tells about the
monitor standby feature under Windows 95.
"Chapter 5: BIOS Setup configuration" on page 5-1
This chapter provides instructions for using the Setup
Utility, where you can view or change your system's
configuration. It also provides information to help you
locate other configuration utilities.
1-2 Chapter 1: Using this book
Part 4: Upgrading and replacing hardware
This part contains information to help you add to or change
the hardware that was installed in your computer at the
factory. It contains the following chapters:
"Chapter 6: Preparing to upgrade" on page 6-1
This chapter contains information to help you prepare to
add or replace adapter cards, drives, and system board
components in your system unit.
"Chapter 7: Adding and removing adapter cards and
drives" on page 7-1
This chapter contains instructions for adding and
removing adapter cards and drives.
"Chapter 8: Adding and replacing system board
components" on page 8-1
This chapter contains instructions for adding and
replacing hardware components on your system board.