IBM Aptiva Series Handbook page 129

Table 4: Error codes and messages (Continued)
Error codes Error messages
72 CMOS Checksum Error
102 I/O Parity Error
103 Press <Esc> to turn off NMI or other
key to reboot
104 Insert system diskette and press
<Enter> to reboot
120 I/O Resource Conflict(s)
121 Memory Resource Conflict(s)
122 IRQ Setting Error
123 Expansion ROM Allocation Failed
Note:
If any of the errors persist after performing the listed corrective actions, see "Chapter 2: HelpWare support and services" on
page 2-1 for information on obtaining service.
Corrective actions
Load the Setup default settings and reboot the system.
Load the Setup defaults and reboot the system.
1. Press Esc to turn off Non-Maskable Interrupt (NMI) and
proceed to boot the system.
2. Press any other key to reboot the system.
1. Insert a system diskette into drive A and press Enter to reboot
the system.
2. If the system works when you boot from drive A, your hard disk
may have a problem.
3. Make sure that your hard disk drive is properly installed. Check
all cable connections.
Enter Setup and set the Reset Resource Assignments to Yes, then
reboot the system.
Enter Setup and set the Reset Resource Assignments to Yes, then
reboot the system.
1. Enter Setup and set the Reset Resource Assignments to Yes,
then reboot the system.
2. If the error message reappears, determine which onboard
device is least necessary and disable it under the Devices and I/
O Ports menu in Setup.
Enter Setup and set the Reset Resource Assignments to Yes, then
reboot the system.
Error codes and messages 9-19