Assembly; Unpacking; Remove Shipping Support Brackets; Install The Wheel Kit - Champion 100554 Operator's Manual

100554 - 3500W WIRELESS START GENERATOR

ASSEMBLY

Your generator requires some assembly. This unit ships from
our factory without oil. It must be properly serviced with fuel
and oil before operation.
If you have any questions regarding the assembly of your
generator, call our Technical Support Team at 1-877-338-0999.
Please have your serial number and model number available.

Unpacking

1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Carefully cut each corner of the box from top to bottom.
Fold each side flat on the ground to provide a surface area
to work with the generator.

Remove Shipping Support Brackets

To protect the generator during shipping, support brackets have
been installed between the engine and frame. These brackets
MUST BE REMOVED BEFORE adding oil or gasoline to the
generator.
DO NOT attempt to run generator without first removing the
shipping support brackets. Damage to the generator as a
result of not removing the brackets will void the warranty.
1. BEFORE filling the engine with oil or gasoline, tip the
generator onto it's recoil end. Tip onto the flattened
cardboard box the generator came in or other protective
surface so as to not scratch the frame.
2. Remove the bolts from the orange support brackets. Bolts
and brackets can be discarded.
3. Tip the generator upright.
NOTICE

Install the Wheel Kit

The wheel kit is not intended for over-the-road use.
Install the Wheels
1. Slide the roll pin (B) through the wheel (A) from the outside.
2. Slide the roll pin through the mount point on the frame.
3. Secure with the R-clip (C).
4. Repeat to attach the second wheel.
B
A
Install the Support Leg
1. Attach the support leg (D) to the generator frame with
flange bolts (E) and flange lock nuts (F).
2. Slowly tip the generator back down so that it rests on the
Wheels and support leg.
ASSEMBLY
CAUTION
C
F
D
E
16