Craftex CX122 User Manual page 11

Figure 8
ADJUSTING BLADE GUIDE BRACKETS
The left and right blade guide brackets (A)
and (B) are adjustable by lock knobs (C)
and sliding the brackets to accommodate
the width of the work-piece. The guide
brackets should be set as close as possible
to the work-piece (as shown in Fig.9)
without interfering with the work-piece or
contacting the table. Once the adjustment is
made, tighten the lock knobs (C).
Figure 9
ADJUSTING THE FEED RATE
The feed rate of the saw arm can be
adjusted by turning the control arm (see
Fig.10) counterclockwise to increase and
clockwise to decrease the feed rate. Do not
turn the control arm more than one turn at a
time. Excessive feed pressure can break
the blade. Insufficient feed pressure dulls
the blade rapidly.
Figure 10
ADJUSTING THE BLADE SAFE PLATE
1. Assemble the blade safe plate (A) to
the blade guard (B) using the screws
supplied. (see Fig.11)
2. Assemble the blade safe plate (C) to
the blade guard (D) using the screws
supplied. (see Fig.11)
11