Assembly Groups; Assembly Group Wheels; Centre Of Gravity/ Wheelbase; Camber - SORG Mio Move Service Record

3.1 Assembly group wheels

3.1.1 Centre of gravity/ wheelbase

The center of gravity (degree of activity), the seat height and the seat angle of the wheelchair
are used for wheelchairs of product group 18.50.03. usually set with the constellation drive and
steering wheels or the perforated plate. The wheelbase is fixed on the Mio and can not be chan-
ged. The center of gravity is adjusted via the seat support angle.

3.1.2 Camber

Variant till 31.12.2016:
In order to change the camber remove the rear
wheels and secure the wheelchair from rolling
away.
• Completely remove the quick-release
axle fitting (A) including the drum brake
arm (B),
• place the camber adjustment (C) on
the rear wheel reception (D) (possible
changes of camber about ± 2°to 7°or
11° from horizontally turning the camber
adjustment 180°),
• replace quick-release axle fitting (A) in-
cluding the drum brake arm (B), screw
on tightly and
• put wheels back on.
(2) Check the distance of the rear wheel to the
side guard by shortly placing the rear wheel on.
(3) Correct the quick-release axle fitting and
turn it as far in or out, that the wheels tire has a
minimum distance of 10 mm to the side guard
or the skirt guard.
• Loosen nuts (A) and (B),
• turn the quick-release axle adapter (C) in
or out,
• retighten the nuts (A) and (B) (tighten-
ing torque nuts M18 fitting 35 Nm).
After adjusting the quick-release axle adapter, be sure to check that the wheel lock functions
properly.
Make sure the distance of the quick-release fitting is the same on the left and right!
The camber and toe adjustment from 01.01.2017 can be found in our service brochure Camber
and toe compensation. This can be found at http://www.sorgrollstuhltechnik.de/
8 of 32
(1)
(2)
(3)
Service Record Mio Move
(B)
(B)
(C)
(A)
(B)
(A)
(C)
2019-07-16