Conveyor Belt Tension; Conveyor Belt Alignment - Meridian SEED EXPRESS Bulk Seed Tender Operator's Manual

Operator's Manual: 240 FF Basic Seed Express

4.3.3 Conveyor Belt Tension:

1. Loosen the locknut on each side of the
hopper roller.
2. Tighten the two tension bolts equally.
- While holding the tension bolt in place,
retighten both locking nuts.
3. Start the conveyor and make sure the belt
is tracking in the center of the hopper roller.
- If the belt is not tracking properly, use
the Belt Tracking alignment procedure to
correct the problem.

4.3.4 Conveyor Belt Alignment:

IMPORTANT:
The hopper roller at the bottom of the
conveyor must be square (roller shaft
must be equal distance from end of
unit) for the belt to track properly.
Note:
If belt is not tracking correctly,
it will move to the loose side.
Tighten loose side or loosen tight side.
1. Adjust one side at a time.
- Loosen the locking nuts on the adjusting
bolt.
2. Tighten or loosen the bolt on one side, to
correct the tracking.
3. Using a wrench, hold the adjusting bolt in
place while tightening the locking nut against
the housing.
4. Slowly, test run the conveyor belt.
- Check if the belt is tracking centered.
- Re-adjust, if needed.
4-8
Bulk Seed Tender
™ ®
Fig 44 - Hopper roller tension bolt
Fig 45 - Discharge roller adjustment bolt, one on each side
®
Revised 01.2022