Substructure - Hanseatic HG4585D107610HW User Manual

Substructure

Recess dimensions
NOTICE
Risk of damage!
Selecting the wrong screws can dam-
age the worktop.
■ Select the correct screws with the ap-
propriate screw length.
■ Use the enclosed screws.
Requirements:
• Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
Set-up, connection and initial start-up
90°
820 mm
Inlet/outlet area
580 mm
and electrical con-
nection.
450 mm
90°
80 mm
100 mm
• Maintain sufficient distance from the walls
and adjacent appliances. The recess
dimensions must at least correspond to
the details in the diagram above, 'recess
dimensions'.
1. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
2. Loosen both screws on the reverse side
of the covering panel and remove them.
Page EN-29