Substructure - Hanseatic HG6085E127635W Manual

– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Insert the mains plug into the socket.

Substructure

NOTICE
Risk of damage!
Selecting the wrong screws can dam-
age the worktop.
Select the correct screws with the ap-
■
propriate screw length.
Use the enclosed screws.
■
59.8 cm
Requirements
• Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
• Maintain sufficient distance from the walls
and adjacent appliances. The measure-
ments of the recess must at least corre-
spond to the details in the diagram above.
1. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
Setup or under-worktop installation and connection
84.5 cm
60.0 cm
2. Loosen both screws on the reverse side
of the covering panel and remove them.
(c)
3. Affix the enclosed condensation-protec-
tive film (c) to the bottom of the work sur-
face. In this way, you will avoid damage to
the work surface as a result of hot steam
which may be emitted from the dishwash-
er if the dishwasher door is left open.
4. Place the dishwasher in the desired position.
5. In order to equalise unevenness in the
floor and set up the dishwasher on a level
horizontal base, you can screw the four
adjustable feet in or out. There are slots
in the appliance feet around the circum-
ference. Insert a screwdriver and turn the
appliance foot.
Use a spirit level to set up the dishwasher.
Page EN-27