Clearing a material blockage
♦
Move the REV/OFF/AUTO/FWD switch
if the material being shredded causes a jam . The appliance now goes into
reverse and the material is ejected .
♦
Alternatively, move the REV/OFF/AUTO/FWD switch
("forward") position if the material causes a blockage . The appliance is now
in forwards operation and the material that is being shredded is pulled in
again .
♦
Move the REV/OFF/AUTO/FWD switch
the jammed material has been ejected .
Turning the appliance off
NOTE
►
We recommend that you switch off the appliance and let it cool down for
about 30 minutes after 3 minutes of operation to prevent overheating .
♦
Switch the appliance off by moving the REV/OFF/AUTO/FWD switch
the OFF position . The power lamp
Overheating protection
This appliance is fitted with overheating protection . If the motor overheats due to
overloading, the appliance switches itself off automatically . The overheat lamp
lights up permanently red until the motor has cooled down sufficiently .
If this occurs, do the following:
WARNING! – RISK OF INJURY!
►
Pull the power plug out of the power socket to prevent unintended starting
of the appliance .
♦
Switch the appliance off by moving the REV/OFF/AUTO/FWD switch
the middle OFF position .
♦
Empty the waste collectors
♦
Allow the appliance to cool down for about 30 minutes .
♦
Replace the plug in the mains power socket .
♦
Switch the appliance on by moving the REV/OFF/AUTO/FWD switch
to the AUTO position . The overheat lamp
appliance has cooled down sufficiently .
■
10
│
GB │ IE │ NI
8
to the REV ("reverse") position
8
to the OFF position as soon as
6
goes out .
w
e
/
.
7
no longer lights up once the
8
to the FWD
8
to
7
8
to
8
UAVS 300 A1