Assembly
WARNING! – RISK OF INJURY!
►
Do not connect the appliance to a power socket during assembly .
►
The cutting blades in the cutter attachment
sharp . Take extreme care when assembling the appliance .
♦
Place the appliance base
♦
Fit the plain castors
on the rear of the base
base
Fig . 1
♦
Place the appliance base
♦
Hold the cutter attachment
and position it over the appliance base
backwards and the opening in the appliance base
♦
Press the cutter attachment
place on the appliance base
♦
Place the small waste collector
Fig . 3
♦
Slide the large waste collector
■
6
│
GB │ IE │ NI
t
0
on the front and the castors with locking levers
t
. Press the castors into the holes on the appliance
t
until you hear them click into place (see fig . 1) .
t
3
3
3
of the appliance are very
flat on the floor with the rear side downwards .
Fig . 2
on the castors after fitting them .
by the two integrated carrying recesses
t
so that the power cable
t
firmly downwards until you hear it lock into
t
(see fig . 2) .
w
in the large waste collector
Fig . 4
e
fully into the appliance base
q
5
1
points
points forwards .
e
(see fig . 3) .
t
(see fig . 4) .
UAVS 300 A1