Maintenance And Cleaning; Error Codes - IKA ICC basic Manual

The device is maintenance-free. It is only subject to the
natural wear and tear of components and their statistical
failure rate.
Cleaning:
For cleaning disconnect the mains
plug!
Use only cleaning agents which have been approved by
IKA ® to clean IKA ® devices.
Dirt Cleaning agent
Dye Isopropyl alcohol
Construction material Water containing tenside/ isopropyl alcohol
Cosmetics Water containing tenside/ isopropyl alcohol
Foodstuff Water containing tenside
Fuel Water containing tenside
For materials which are not listed, please request
information from IKA
Wear protective gloves while cleaning the device.
Electrical devices may not be placed in the cleansing agent
for the purpose of cleaning.
Do not allow moisture to get into the device when cleaning.
Before using another than the recommended method for
cleaning or decontamination, the user must ascertain with
IKA ® that this method does not damage the device.
Any malfunctions during operation will be identified by an error message on the display.
Proceed as follows in such cases:
Switch off device using the main switch at the back of the device
Carry out corrective measures
Restart device
Error code Effect
Err 02 Pump off
Heating off
Err 03 Pump off
Heating off
Err 04 Pump off
Heating off
Pump off
Err 05
Heating off
Err 06 Pump off
Heating off
Err 07 Pump off
Heating off
Pump off
Err 08
Heating off

Maintenance and cleaning

®
application support.
Cause
Motor over current (rate current)
Motor over current (Max. current) - Reduce pump motor speed
Motor hall signal missing
Too high liquid level
Too low liquid level
Too high voltage
Too low voltage
Spare parts order:
When ordering spare parts, please give:
- machine type
- manufacturing number, see type plate
- item and designation of the spare part,
see www.ika.com, spare parts diagram and list
- Software version.
Repair:
Please send the device for repair only after it has
been cleaned and is free from any materials which
may constitute a health hazard.
For repair, please request the "Decontamination Cer-
tificate" from IKA
IKA ® website www.ika.com.
If you require servicing, return the device in its original
packaging. Storage packaging is not sufficient. Please also
use suitable transport packaging.

Error codes

Solution
- Reduce pump motor speed
- Use fluid with lower viscosity
- Check if the pump impeller is blocked
- Use fluid with lower viscosity
- Check if the pump impeller is blocked
- Reduce pump motor speed
- Use fluid with lower viscosity
- Check if the pump impeller is blocked
- Check the liquid level and buoyage
- Check the liquid level and buoyage
- Check the mains power
- Check the mains power
® , or download printout of it from the
15